Earthquake Science Center Seminars

U.S. Geological Survey
Earthquake Science Center Seminars

Open dialogue about important issues in earthquake science presented by Center scientists, visitors, and invitees.

Episodios

  1. 2 OCT

    The mechanics of (laboratory) earthquakes and aseismic slip due to fluid injection

    Sara Beth Cebry, U.S.G.S. luid injection decreases effective normal stress on faults and can stimulate seismicity far from active tectonic regions. Based on earthquake nucleation models and measured stress levels, slip will be stable, aseismic, and limited to the fluid pressurized region—contrary to observed increases in seismicity. To understand how fluid injection effects earthquake initiation, rupture, and termination, I used large-scale laboratory faults to experimentally link effects of direct fluid injection to rupture behavior. Comparison between the nucleation of dynamic events with and without fluid pressure showed that rapid fluid injection into a low permeability fault increases multi-scale stress/strength heterogeneities that can initiate seismic slip. Factors that increase the intensity of the heterogeneity, such as increased injection rate or background normal stress, promote the initiation of small seismic events that have the potential to “run away” and propagate beyond the fluid pressurized region. Whether or not the seismic slip can “run away” depends on the background shear stress levels. When the fault was near critically stressed, dynamic slip initiated quickly after high fluid pressure levels were reached. The dynamic slip event propagated far beyond the fluid pressurized region. In comparison, when the fault was far from critically stressed, dynamic slip initiated hundreds of seconds after high injection pressures were reached and this event was limited in size by the region affected by fluid pressure. We conclude that localized decreases in effective normal stress due to fluid pressure can initiate slip, sometimes seismic slip, but the background shear stress controls whether or not that slip and grows into a large earthquake.

    1 h
  2. 25 SEPT

    Rapid, physics-informed seismic wavefield predictions using high-performance computing and reduced-order modeling techniques

    John Rekoske, University of California San Diego Rapidly estimating the ground shaking produced by earthquakes in real-time, and from future earthquakes, are important challenges in seismology. Numerical simulations of seismic wave propagation can be used to estimate ground motion; however, they require large amounts of computing power and are too slow for real-time problems, even with modern supercomputers. Our aim is to develop a method using both high-performance computing and machine learning techniques to obtain a close approximation of simulated seismic wavefields that can be solved rapidly. This approach integrates physics into the source- and site-specific ground motion estimates used for real-time applications (e.g., earthquake early warning) as well as many-source problems (e.g., probabilistic seismic hazard analysis). Specifically, I will focus this talk on applying data-driven reduced-order models (ROMs) that are based on the interpolated proper orthogonal decomposition method. I will discuss our work using ROMs to (1) instantaneously generate peak ground velocity maps and (2) to rapidly generate three-component velocity seismograms for earthquakes in the greater Los Angeles area. The approach is flexible, in that it can generate 3D elastodynamic Green’s functions which we can use to simulate seismograms for complex kinematic earthquake rupture models. Lastly, I will show how this approach can provide accurate, near-real-time wavefields that could be used to rapidly inform about possible earthquake damage.

    1 h
  3. 4 SEPT

    Source, path, and site effects and their role on earthquake ground motions

    Haiyang Kehoe, USGS Seismograms contain information of an earthquake source, its path through the earth, and the local geologic conditions near a recording site. Ground shaking felt on Earth’s surface is modified by each of these contributions–the spatiotemporal evolution of rupture, three-dimensional subsurface structure, and site conditions all have a substantial impact on hazards experienced by exposed populations. In this talk, I highlight three studies that have improved our understanding of ground motion variability arising from source, path, and site effects. First, I describe the rupture process of the 2017 Mw 7.7 Komandorsky Islands earthquake, which reached supershear speeds following a rupture jump across a fault stepover, and demonstrate the enhanced hazard associated with supershear ruptures across Earth’s complex transform fault boundaries. Second, I compare high-frequency wavefield simulations of Cascadia earthquakes using various tomography models of the Puget Sound region, Washington State to highlight the role of basin structure on ground motion amplification. Third, I show horizontal-to-vertical spectral ratio maps of the continental United States and emphasize the continued importance of region-specific constraints on site characterization. While each study demonstrates progress towards understanding the individual roles of source, path, and site effects on damaging earthquake ground motions, together they underscore distinct challenges for improving seismic hazard models and their uncertainties.

    1 h
  4. 21 AGO

    Geometric Parametrization of Sedimentary Basins in Southern California for Site Response Analysis and Modelling

    Rashid Shams, University of Southern California Site response in sedimentary basins is partially governed by mechanisms associated with three-dimensional features. This includes the generation of propagating surface waves due to trapped and refracted seismic waves, focusing of seismic energy due to basin shape and size, and resonance of the entire basin sediment structure. These mechanisms are referred to as basin effects and they lead to a significant increase in the amplitude and duration of the observed ground motions from earthquake events. Currently, ground motion models (GMMs) incorporate basin effects using the time-averaged shear-wave velocity in the upper 30 m (V_S30), and the isosurface depths (depth to a particular shear wave velocity horizon, z_x). This approach captures site response features associated with the basin but uses parameters that are one-dimensional in nature and therefore are limited in their description of the lateral and other three-dimensional (3D) contributing effects. This work explores geometric features as predictive parameters in the development of region-specific models to improve the characterization of site response in sedimentary basins. In this work we constrained basin shape using depth to sedimentary basement (depth to a particular shear wave velocity horizon i.e., z_1.5 and z_2.3) and depth to crystalline basement (z_c,b) which are derived and validated using systematic exploration of geological cross sections and Community Velocity Model (CVM) profiles over Los Angeles Basin (LAB). Finally geometric parameters such as includes Standard deviation of zcb, Standard deviation of Absolute difference between z_1.5 and z_cb, distance from basin margin, and Spatial Area of Influence based on V_S30 are computed based on finalized shape. Residual analysis is employed to access derived geometric parameters for their ability to reduce bias and uncertainty in basin site response analysis.

    1 h
  5. 7 AGO

    Splay fault dynamics at subduction and rift margins: insight from 3D dynamic rupture modeling of the Cascadia megathrust and the Mai’iu low-angle normal fault

    James Biemiller, USGS An unresolved aspect of tsunami generation in great subduction earthquakes is the offshore competition between coseismic deformation mechanisms, such as shallow megathrust slip, slip on one or more splay faults, and off-fault plastic deformation. In this presentation, we first review results from data-constrained 3D dynamic rupture modeling of an active plate-boundary-scale low-angle normal fault, the Mai’iu fault, that show how stress, fault structure, and the strength and thickness of overlying sediments influence shallow coseismic deformation partitioning in an extensional setting. Similar modeling approaches can shed light on shallow coseismic deformation in contractional settings, such as the Cascadia subduction zone (CSZ). Along the northwestern margin of the U.S., robust paleoseismic proxies record multiple M>8 paleoearthquakes over the Holocene, despite limited modern interface seismicity. Additionally, growth strata in the outer wedge record Late Quaternary slip on active landward- and seaward-vergent splay faults inboard of prominent variably-vergent frontal thrusts at the deformation front. The relative importance of megathrust vs. splay fault slip in generating tsunami hazards along the Pacific Northwest coastline is relatively unconstrained. Here, we develop data-driven 3D dynamic rupture models of the CSZ to analyze structural controls on shallow rupture processes including slip partitioning across the frontal thrusts, splays, and underlying decollement. Initial simulations show that trench-approaching ruptures typically involve meter-scale slip on variably oriented preexisting planar splay faults. Splay slip reduces slip on the subduction interface in a shadowed zone updip of their intersection, with greater splay slip leading to stronger shadowing. We discuss two structural controls on splay faults’ coseismic slip tendency: their dip angle and vergence. Gently dipping splays host more slip than steeply dipping ones and seaward-vergent splays host more slip than landward-vergent ones. We attribute these effects to distinct static and dynamic mechanisms, respectively. Finally, we show initial results from simulations with newly mapped frontal thrust geometries from CASIE21 seismic reflection data and discuss future directions for our CSZ dynamic rupture modeling project.

    1 h
  6. 24 JUL

    Historical Seismic Data for the Future: Preservation, Digitization, and Utility

    Thomas Lee, Harvard University Since the first seismograms were recorded in the late 19th century, the seismological community has accumulated millions of ground motion records on both paper and film. While almost all analog seismic recording ended by the late 20th century, replaced by digital media, the still-extant archives of paper and film seismograms are invaluable for many ongoing scientific applications. This long-running record of ground motion is crucial for developing understanding of how both natural and anthropogenic events have changed the Earth and its processes throughout the last century. Today, most of these records are housed in institutions with limited resources, which must prioritize certain objects or types of objects for preservation and access. For example, when seismologists today are forced to triage collections, the bulky paper-records are oftentimes more at-risk for deaccessioning than more compact film copies. However, alterations introduced in reformatting (i.e., paper to film) as well as preservation requirements of the various records are not often fully understood or appreciated. To make these decisions in an informed way, it is vital to know the stability of the recording media and the level of accuracy that can be obtained from these different records. For example, image distortion and available color depth in paper and microfilm copies can result in discrepancies in derived time series which could lead to significant errors in products such as earthquake magnitude and location. We present lessons learned from recent experiences with modern archiving and processing of legacy seismic data. These include techniques for data rescue (including both scanning and conversion to time series), the importance of characterizing the full processing chain, and the importance of involving archivists and citizen science in preservation efforts.

    1 h

Acerca de

Open dialogue about important issues in earthquake science presented by Center scientists, visitors, and invitees.

También te podría interesar

Para escuchar episodios explícitos, inicia sesión.

Mantente al día con este programa

Inicia sesión o regístrate para seguir programas, guardar episodios y enterarte de las últimas novedades.

Elige un país o región

Africa, Oriente Medio e India

Asia-Pacífico

Europa

Latinoamérica y el Caribe

Estados Unidos y Canadá